Mechanics of Coatings, Proceedings of the 16th Leeds-Lyon Symposium on Tribology held at The lnstitut National des Sciences Appliquées

Content: 
Edited by
Page iii

Copyright page
Page iv

Introduction
Pages ix-x
Maurice Godet

Dedication
Page xi

Paper I (i) On the elastic constants of thin solid lubricant films Original Research Article
Pages 3-13
M.N. Gardos

Paper I (ii) Frictional properties of lubricating oxide coatings Original Research Article
Pages 15-25
M.B. Peterson, S.J. Calabrese, S.Z. Li, X.X. Jiang

Paper I (iii) Elastic and viscoelastic analysis of two multiply layered cylinders rolling over each other with coulomb friction Original Research Article
Pages 27-34
J.J. Kalker

Paper II (i) Analysis of damage mechanism using the energy release rate Original Research Article
Pages 37-44
P. Destuynder, T. Nevers

Paper II (ii) Integrity of wear coating subjected to high-speed asperity excitation Original Research Article
Pages 45-52
F.D. Ju, J.-C. Liu

Paper II (iii) Coating design methodology Original Research Article
Pages 53-59
M. Godet, Y. Berthier, J.-M. Leroy, L. Flamand, L. Vincent

Paper III (i) Reduction in friction coefficient in sliding ceramic surfaces by in-situ formation of solid lubricant coatings Original Research Article
Pages 63-72
A. Gangopadhyay, S. Jahanmir, B.E. Hegemann

Paper III (ii) In-situ engineered oxide coatings Original Research Article
Pages 73-79
H.-S. Hong, W.O. Winer

Paper Ill (iii) A morphological study of contact fatigue of TiN coated rollers Original Research Article
Pages 81-88
H.S. Cheng, T.P. Chang, W.D. Sproul

Paper IV (i) A full solution to the problem of film thickness prediction in natural synovial joints Original Research Article
Pages 91-102
D. Dowson, J. Yao

Paper IV (ii) Finite element analysis of EHD lubrication of rubber layers Original Research Article
Pages 103-110
A. Gabelli, B. Jacobson

Paper IV (iii) Analyses of shear deformations between cylinders with and without surface films Original Research Article
Pages 111-117
J.W. Kannel, T.A. Dow

Paper V (i) Effects of microstructure and adhesion on performance of sputter-deposited MoS2 solid lubricant coatings Original Research Article
Pages 121-128
P.D. Fleischauer, M.R. Hilton, R. Bauer

Paper V (ii) Role of transfer films in wear of MoS2 coatings Original Research Article
Pages 129-138
S. Fayeulle, P.D. Ehni, I.L. Singer

Paper V (iii) Assessing the durability of organic coatings Original Research Article
Pages 139-147
M.J. Adams, B.J. Briscoe, A.L. Carter, P.J. Tweedale

Paper VI (i) Effect of surface coatings in a rough normally loaded contact Original Research Article
Pages 151-156
Ph. Sainsot, J.M. Leroy, B. Villechaise

Paper VI (ii) Elastic behaviour of coated rough surfaces Original Research Article
Pages 157-165
J.I. McCool

Paper VII (i) Scratch tests on hard layers Original Research Article
Pages 169-174
A.G. Tangena, S. Franklin, J. Franse

Paper VII (ii) A theoretical approach of hardness distribution in rigid perfectly plastic coated materials Original Research Article
Pages 175-182
M.L. Edlinger, E. Felder

Paper VII (iii) Damage mechanisms of hard coatings on hard substrates: a critical analysis of failure in scratch and wear testing Original Research Article
Pages 183-192
R. Rezakhanlou, J. von Stebut

Paper VIII (i) Stress determination in elastic coatings and substrate under both normal and tangential loads Original Research Article
Pages 195-201
J.M. Leroy, B. Villechaise

Paper VIII (ii) A survey of cracks in layers propelled by contact loading Original Research Article
Pages 203-208
D.A. Hills, D. Nowell, A. Sackfield

Paper VIII (iii) A Statistical approach for cracking of deposits: determination of mechanical properties Original Research Article
Pages 209-213
A. Mezin, R. Ramboarina, J. Lepage

Paper IX (i) Young's modulus of Tin and Tic coatings Original Research Article
Pages 217-222
L. Chollet, C. Biselli

Paper IX (ii) A method for in situ determination of Young's modulus of deposits Original Research Article
Pages 223-230
J.P. Chambard, M. Nivoit

Paper X (i) Use of a polyethylene coating to improve the biotribology of a hemiarthroplasty implant Original Research Article
Pages 233-240
M. Laberge, G. Drouin, J.D. Bobyn, C.H. Rivard

Paper X (ii) Comparison of theoretical and experimental values for friction of lubricated elastomeric surface layers under transient conditions. Original Research Article
Pages 241-250
J.R. Gladstone, J.B. Medley

Paper X (iii) A preliminary investigation of the ‘cushion bearing’ concept for joint replacement implants Original Research Article
Pages 251-260
D.D. Auger, J.B. Medley, J. Fisher, D. Dowson

Paper XI (i) The influence of elastic deformation upon film thickness in lubricated bearings with low elastic modulus coatings Original Research Article
Pages 263-269
D. Dowson, Z. Jin

Paper XI (ii) Frictional mechanism in uncoated and zinc-coated steel sheet forming - theoretical and experimental results Original Research Article
Pages 271-279
V. Samper, E. Felder

Paper XI (iii) Effect of nitrogen ion implantation on the friction and wear properties of some plastics Original Research Article
Pages 281-286
M. Watanabe, H. Shimura, Y. Enomoto

Paper XII (i) The effect of continuous au sputter deposition on the enhancement of growth of transfer particles Original Research Article
Pages 289-293
K. Hiratsuka, L.L. Hu, T. Sasada

Paper XII (ii) Elasto-plastic finite element analysis of axisymmetric indentation using a simple personal computer Original Research Article
Pages 295-301
M. Gueury, P. Bagur, R. Rexakhanlou, J. von Stebut

Paper XIII (i) The oxide film and oxide coating on steels under boundary lubrication Original Research Article
Pages 305-311
Y.-W. Zhao, J.-J. Liu, L.-Q. Zheng

Paper XIV (i) A survey of research in acoustic microscopy applied to metallurgy Original Research Article
Pages 315-322
J. Attal, R. Caplain, H. Coelho-Mandes, K. Alami, A. Saied

Paper XIV (ii) Detection of interface defects in layered materials by photothermal radiometry Original Research Article
Pages 323-328
M. Heuret, E. Van Schel, M. Egée, R. Danjoux

Paper XIV (iii) A low cycle fatigue wear model and its application to layered systems Original Research Article
Pages 329-334
A.G. Tangena

Paper XV (i) The inter-relationship between coating microstructure and the tribological performance of PVD coatings Original Research Article
Pages 337-349
S.J. Bull, D.S. Rickerby

Paper XV (ii) Identificaiton and role of phosphate coating for tribological applications Original Research Article
Pages 351-357
G.T.Y. Wan, R.J. Samalley, G. Schwarm

Paper XV (iii) Protective coating for application in seawater Original Research Article
Pages 359-368
M.F. Lizandier, E. Lanza, A. Seabaoun, A. Giround, P. Guiralendenq

Paper XVI (i) Lubrication influences on the wear of piston-ring coatings Original Research Article
Pages 371-377
J.C. Bell, K.M. Delargy

Paper XVI (ii) Wear behaviour of Cr2O3 and Al2O3 plasma sprayed coatings under lubricated and non-lubricated conditions Original Research Article
Pages 379-386
R. Vijande, F.J. Belzunce, J.E. Fernández, M.C. Pérez, A. Rincón

Paper XVII (i) Influence of viscoelastic parameters on coated bearing behaviour Original Research Article
Pages 389-396
Y.T. Sun, B. Bou-Said, B. Fantino

Paper XVIII (i) Morphological aspects of the friction of hot-filament-grown diamond thin films Original Research Article
Pages 399-407
P.J. Blau, C.S. Yust, L.J. Heatherly, R.E. Clausing

Paper XVIII (ii) Factors affecting the sliding performance of titanium nitride coatings Original Research Article
Pages 409-415
F.E. Kennedy, L. Tang

Paper XVIII (iii) The mechanism of failure of coatings in roller tests Original Research Article
Pages 417-425
J. Vižintin

Paper Paper XIX (i) Measurements of thin films adhesion and mechanical properties with indentation curves Original Research Article
Pages 429-434
J.L. Loubet, J.M. Georges, Ph. Kapsa

Paper XIX (ii) Soft metallic coatings in metal forming processes Original Research Article
Pages 435-444
P. Montmitonnet, F. Delamare, E. Darque-Ceretti, J. Mstowski

Paper XIX (iii) Deformation and fracture of hard coatings during plastic indentation Original Research Article
Pages 445-449
D.M. Elliott, I.M. Hutchings

Paper XX (i) Coating evaluation methods: a round robin study Original Research Article
Pages 453-463
H. Ronkainen, S. Varjus, K. Holmberg, K.S. Fancey, A.R. Pace, A. Matthews, B. Matthes, E. Broszeit

Paper XX (ii) The effect of dynamic loads in tribometers - analysis and experiments Original Research Article
Pages 465-473
H. Heshmat

Written contributions
Pages 477-480

List of Authors
Pages 481-487

List of Delegates
Pages 489-498