IEEE Std 519-1992 Recommended Practices and Requirements for Harmonic Control in Electrical Power Systems, IEEE Std 519-1992

1.3 Application......Page 8
References......Page 9
3.1 Definitions......Page 10
3.2 Letter Symbols......Page 13
4.1 Converters......Page 15
4.2 Arc Furnaces......Page 23
Inverters for Dispersed Generation......Page 24
4.5 Electronic Phase Control......Page 25
4.7 Switch Mode Power Supplies......Page 26
4.8 Pulse Width Modulated (PWM) Drive......Page 27
5.1 General......Page 28
5.2 Resonant Conditions......Page 29
Effect of System Loading......Page 30
Typical System Characteristics......Page 32
6.2 Motors and Generators......Page 36
6.3 Transformers......Page 37
6.5 Capacitors......Page 38
6.6 Electronic Equipment......Page 39
6.8 Switchgear and Relaying......Page 40
6.9 Telephone Interference......Page 41
6.10 Static Power Converters......Page 44
7.1 Converter Power Factor......Page 45
8.3 Modeling Guidelines for Harmonic Analysis......Page 58
Line Notching Calculations (for Low-Voltage Systems)......Page 61
Total Harmonic Distortion......Page 64
System Calculations (Low Voltage Below......Page 65
Displacement Power Factor Improvement Calculation......Page 66
Voltages and Currents......Page 69
Requirements for Instrument Response......Page 70
9.4 Presentation of Harmonic Data......Page 71
9.5 Transducers for Harmonic Measurements......Page 73
10.4 Current Distortion Limi......Page 78
11.3 Short-Duration Harmonics......Page 84
11.5 Voltage Distortion Limits......Page 85
11.6 Limits of Interference With Communication Circuits......Page 86
12.5 Performing Detailed Simulations......Page 88
12.6 Developing Solutions to Harmonic Problems......Page 89
13.1 Example of Large Industrial Plant Furnished at Transmission Voltage......Page 90
13.2 Example of Several Users on a Single Distribution Feeder......Page 91
14 Bibliography......Page 100