Energy and Environment Engineering and Management

Energy and Environment Engineering and Management......Page 2
Committees......Page 5
Sponsors......Page 9
Preface......Page 10
Table of Contents......Page 11
Activated Carbons Prepared from Natural and Synthetic Raw Materials with Potential Applications in Gas Separations......Page 13
Sustainable Manufacturing in Aerospace Industry – Analysis of the Viability of Intermediate Stages Elimination in Sheet Processing......Page 20
Low Environmental Impact Machining Processes of Composite Materials Applied to the Aerospace Sector......Page 26
Sand Mining Pool Eutrophication (Vale do Paraíba, São Paulo, Brazil): Preliminary Assessment......Page 31
Recovery of Degraded Areas in Vale do Paraíba, São Paulo, Brazil: Performance Indicators......Page 37
Surface Wave Energy Capture System (A New Proposition)......Page 45
Environmental Education and Energetic Efficiency: Reports on Brazilian Projects in the Sake of Socio-Environmental Sustainability......Page 50
Free Cooling with Phase Change Materials (PCM)......Page 57
Interface Potential Modeling in a Finite Crystal......Page 63
Hydrothermal Stability of Ordered Mesoporous Titanosilicate Materials Prepared at Room Temperature......Page 71
Composites in the Design Optimization of Biconvex Refractive Solar Concentrators. Study and Calculation of Prototypes......Page 79
SOM-SEM-EDS Identification of Tool Wear Mechanisms in the Dry-Machining of Aerospace Titanium Alloys......Page 84
Ecological Design, an Objective in the Projects Engineering Area......Page 90
Use of Centrifugal Pumps Operating as Turbines for Energy Recovery in Water Distribution Networks. Two Case Study......Page 94
Leds, toward the Best Energy Efficiency in Lighting......Page 100
Comparison of Simple Illuminance Model Performances under Clear-Sky Conditions for Athens (Greece)......Page 105
Study of Thermal Conductivity of Materials Made of Sludges Water Depuration of the Brewing Industry......Page 110
Treatment of Urban Waste Water Sludges by Means of his Appraisement for Incorporation in Ceramic Matrix......Page 116
Preliminary Study of the Influence of Machining Conditions in the Response to Corrosion of UNS-A92024 Alloy......Page 122
Computer Simulation and Depth Profiling of Light Nuclei by Nuclear Techniques......Page 127
Environmental, Energetic and Economic Analysis about the Energy Source for a Vehicle with Typical Portuguese Urban Use......Page 133
Identification, Analysis and Evolution of the Mechanisms of Wear for Secondary Adhesion for Dry Turning Processes of Al-Cu Alloys......Page 144
Radiation Safety of Old Uranium Mining Waste Dumps in Portugal......Page 150
Environmental Remediation and the Legacy of Uranium Mining Waste in Portugal and Europe. Lessons to Retain......Page 160
Keywords Index......Page 166
Authors Index......Page 168