Analog Signal Processing

Title Page
Table of Contents
Preface
1 Signals and Sigual Processing
	1.1 Signals, Information, Interference, and Noise
	1.2 Signal Classification
	1.3 Dynamic Range and Signal-to-Noise Ratio
	1.4 Functions in Analog Signal Processing
	1.5 Errors in Analog Signal Processing
	1.6 Problems
	References
2 Voltage Amplification
	2.1 Ideal Voltage Amplifiers
	2.2 Practical Voltage Amplifiers
	2.3 Building Blocks for Voltage Amplifiers
	2.4 dc Amplifiers
	2.5 ac Amplifier
	2.6 Composite Amplifiers
	2.7 Programmable-Gain Amplifiers
	2.8 Problems
	References
3 Current-to-Voltage and Voltage-to-Current Conversion
	3.1 Ideal Current-to-Voltgage Converters
	3.2 Practical Current-to-Voltage Converters
	3.3 Building Blocks for Current-to-Voltage Converters
	3.4 Current-to-Voltage Converter Amplifiers
	3.5 Ideal Voltage-to-Current Converters
	3.6 Practical Voltage-to-Current Converters
	3.7 Operational Transconductance Amplifiers
	3.8 Voltage-to-Current Converter Circuits
	3.9 Other Components and Circuits for Processing Currents
	3.10 Problems
	References
4 Linear Analog Functions
	4.1 Addition
	4.2 Subtraction
	4.3 Differentiation
	4.4 Integration
	4.5 Impedance Transformation and Conversion
	4.6 Problems
	References
5 ac/dc Signal Conversion
	5.1 Description of ac
	5.2 Signal Rectification
	5.3 Peak and Valley Detection
	5.4 rms-to-dc Conversion
	5.5 Amplitude Demodulation
	5.6 Problems
	References
6 Other Nonlinear Analog Functions
	6.1 Voltage Comparison
	6.2 Voltage Limiting (Clipping)
	6.3 Logarithmic Amplifiers
	6.4 Exponential (Antilog) Amplifiers
	6.5 Analog Multipliers
	6.6 Analog Dividers
	6.7 Problems
	References
7 Analog Signal Filtering
	7.1 Introduction to Filtering and Filter Design
	7.2 Components for Filter Implementation
	7.3 Low-Pass Filters
	7.4 High-Pass Filters
	7.5 Bandpass Filters
	7.6 Band-Reject (Notch) Filters
	7.7 All-Pass Filters
	7.8 Nonlinear Analog Filters
	7.9 Input Filters and Circuit Protection
	7.10 Problems
	References
8 Analog Signal Switching, Multiplexing, and Sampling
	8.1 Introduction to Signal Acquisition
	8.2 Analog Switches
	8.3 Analog Multiplexers
	8.4 Crosspoint Switch Arrays
	8.5 Sample-and-Hold Amplifiers
	8.6 Problems
	References
9 Error Analysis and Reduction
	9.1 Error Sources in Analog Signal Processing
	9.2 Error Budget and Calculation
	9.3 Error Reduction by Internal Calibration
	9.4 Offset Reduction Techniques
	9.5 Gain-Error Reduction Techniques
	9.6 Problems
	References
10 Interference and its Reduction
	10.1 Interference Coupling in Electronic Circuits
	10.2 Grounding for Interference Reduction
	10.3 Shielding of Conductors and Circuits
	10.4 Signal Isolation. Isolation Amplifiers
	10.5 Problems
	References
11 Noise, Drift, and Their Reduction
	11.1 Noise Fundamentals
	11.2 Noise in Electronic Components and Circuits
	11.3 Drift in Electronic Components
	11.4 Environmental Noise (Pseudonoise)
	11.5 Problems
	References
APPENDIX A: Web Sites of Interest in Analog Signal Processing
APPENDIX B: Standard EIA Resistor and Capacitor Values
INDEX