Injection Molding. Technology and Fundamentals

Content: 
Injection Molding, Pages I-XXIV, Musa R. Kamal, Avraam Isayev, Shih-Jung Liu
Part I: Background and Overview: Injection Molding: Introduction and General Background, Pages 1,3-70, Musa R. Kamal
Part II: Injection Molding Machinery and Systems: Injection Molding Machines, Tools, and Processes, Pages 71,73-131, Tadamoto Sakai, Kenji Kikugawa
The Plasticating System for Injection Molding Machines, Pages 133-169, Mark A. Spalding, Kun Sup Hyun
Non-Conventional Injection Molds, Pages 171-194, António M. Cunha, António J. Pontes
Gas Assisted Injection Molding, Pages 195-222, Shih-Jung Liu
Water Injection Techniques (WIT), Pages 223-250, Walter Michaeli
Part III: Injection Molding of Complex Materials: Flow Induced Fiber Micro-Structure in Injection Molding of Fiber Reinforced Materials, Pages 251,253-272, Michel Vincent
Injection Foam Molding, Pages 273-307, X. Xu, C.B. Park
Powder Metal Injection Molding, Pages 309-340, James F. Stevenson
Micro Injection Molding, Pages 341-393, Volker Piotter, Guido Finnah, Thomas Hanemann, Robert Ruprecht
Part IV: Process Visualization, Control, Optimization, and Simulation: Internal Visualization of Mold Cavity and Heating Cylinder, Pages 395,397-438, Hidetoshi Yokoi
Injection Molding Control, Pages 439-510, Furong Gao, Yi Yang
Optimal Design for Injection Molding, Pages 511-552, Kalonji K. Kabanemi, Abdessalem Derdouri, Jean-François Hétu
Development of Injection Molding Simulation, Pages 553-598, Peter Kennedy
Three-Dimensional Injection Molding Simulation, Pages 599-651, Luisa Silva, Jean-Francois Agassant, Thierry Coupez
Viscoelastic Instabilities in Injection Molding, Pages 653-684, G.W.M. Peters, A.C.B. Bogaerds
Part V: Microstructure Development, Characterization, and Prediction: Evolution of Structural Hierarchy in Injection Molded Semicrystalline Polymers, Pages 685,687-730, M. Cakmak, B. Yalcin
Modeling Aspects of Post-Filling Steps in Injection Molding, Pages 731-778, Roberto Pantani, Giuseppe Titomanlio
Volumetric and Anisotropic Shrinkage in Injection Moldings of Thermoplastics, Pages 779-808, A.I. Isayev, Keehae Kwon
Three-Dimensional Simulation of Gas-Assisted and Co-Injection Molding Processes, Pages 809-850, Jean-François Hétu, Florin Ilinca
Co-Injection Molding of Polymers, Pages 851-915, A.I. Isayev, Nam Hyung Kim
Subject Index, Pages 917-926, Musa R. Kamal, Avraam Isayev, Shih-Jung Liu